Bite Tester GT-M45
Product Introduction
|
Application:
Bite Tester is used to test whether the toys has cracked after bite test, and if it has produced hazardous sharp points, hazardous sharp edges, and hazardous small parts after crack.
Standards:
16 CFR 1500
|
Dimensions
|
The test article shall be placed in the contact mechanism in any reasonable position for a penetration of 0.25 to 0.5 inch (0.64 to 1.27 centimeters), which position utilizes less than 180 degrees of the arc of the contact mechanism, and a test load shall be evenly applied within 5 seconds. This load shall be maintained for an additional 10 seconds.
|
Key Specifications
Application Industry
All kinds of Toys can be tested on the Bite Tester
