GE 531X305NTBAPG1 | General Electric | Controls Module

General Electric   531X305NTBAPG1   !!!  ---mail to: sales3@amikon.cn  

  Email:     sales3@amikon.cn       

                                                                     Contact:  Jessica                   |   Skype:     jessica01235483

                                                                     Wechat:   hu18030235311   |  Mobile:   86-18030235311(WhatsApp)

There are two means to operate the IC698CPE010: the three-position run/stop switch and connecting the device to a computer and running the appropriate software. Connecting this device to a computer is possible via the serial or Ethernet ports. 

Note: Using the Ethernet port will require IP addressing and a Cat5 cable. For serial connections, the SNP protocol is used. For configuration and programming of this device, Proficy Machine Edition PLC-Logic Developer software is used on the attached computer. Configuration data is secured with a password.

General Electric   531X305NTBAPG1

GE  531X305NTBAPG1 | General Electric | Controls Module

         sales3@amikon.cn  

Follow the instructions in the product manual while installing the IC698CPE010. Disable rack power. Document the Media Access Control (MAC) address of the device. Securely mount and ground the device into slot one of the rack, the designated CPU slot.

Emal:sales3@amikon.cn                                                                                         

Are you looking for a suitable sustainable partner to ensure your industrial electronics run smoothly or in the event of a failure？
If so, then Moore Automation is your best choice.