GE IS200TTURH1B | General Electric | Power Module

General Electric   IS200TTURH1B  !!!  ---mail to: sales3@amikon.cn  

  Email:     sales3@amikon.cn       

                                                                     Contact:  Jessica                   |   Skype:     jessica01235483

                                                                     Wechat:   hu18030235311   |  Mobile:   86-18030235311(WhatsApp)

When the PLC is running in Microcycle Sweep mode (refer to section 4 for information about Microcycle Sweep mode), a wind-down or logic solution period may occur after the PLC is commanded to Stop mode. This wind-down period is equal to the amount of time that the currently executing program(s) take to complete their execution unless that amount of time exceeds 2.5 seconds. 

If the currently executing programs exceed 2.5 seconds in their attempt to complete their executions, a fault will be logged in the PLC fault table, and the CPU will complete its transition to Stop mode. During the wind-down period, no additional programs (including Interrupt programs and blocks) will be scheduled for execution. 

General Electric   IS200TTURH1B

GE  IS200TTURH1B | General Electric | Power Module

         sales3@amikon.cn  

In the CPU, power-up will be either a quick power-up (a warm start) or a full power-up (a cold start), depending on whether the CPU is able to go to Run mode after powering up. If all the conditions are met for the CPU to go to Run mode

Emal:sales3@amikon.cn                                                                                         

Are you looking for a suitable sustainable partner to ensure your industrial electronics run smoothly or in the event of a failure？
If so, then Moore Automation is your best choice.