GE SN85110243 | General Electric | Input Module

GE   General Electric  SN85110243  !!!  ---mail to: sales3@amikon.cn  

  Email:     sales3@amikon.cn       

                                                                     Contact:  Jessica                   |   Skype:     jessica01235483

                                                                     Wechat:   hu18030235311   |  Mobile:   86-18030235311(WhatsApp)

Connector 3 PL contains the necessary connection points for the IC66* bus. 

The serial bus must be terminated at each end by its characteristic impedance. If the Bus Controller is at the end of the bus, select the correct impedance for the cable length and type, as shown in table 2. 

Included with each board are two small packages containing two resistors each. Use the resistors in the package labeled 44A730116-G01 for those cables with 150 ohm impedance. Use the resistors in the package labeled 44A730116-G02 for those cables with 75 ohm impedance. Also supplied with each board are two prefabricated plugs for termination of both 75 ohm and 150 ohm cables at the last IC66* I/O block on the Serial bus. 

GE   General Electric  SN85110243

GE  SN85110243  | General Electric | Input Module

         sales3@amikon.cn  

Other busses connected to the same CPU may use different types of cable (unless joined by a Bus Switching Module, as shown in figure 6). Cable specifications are found in Table 2 . 

Emal:sales3@amikon.cn                                                                                         

1st, we will state the condition of the parts honestly when quote ;
2nd, we will test the quality of the goods before shipment ;
3rd, we will be responsilbe when the parts get in any problems .